3. To have the LEDs continue to flow from one color to
another, press the Color Mode button again.
BRIGHTNESS ADJUSTMENT
To adjust the brightness (25%, 50%, 75% or 100%), press up
or down on the directional pad while holding the Color Mode
button.
1. Up raises the brightness.
2. Down lowers the brightness.
NOTE: Brightness can only be adjusted when locked on a
specific color or color combination.
USING THE MAPPABLE BUTTONS
The M1 and M2 mappable buttons on the back of the
controller can be mapped to the following action buttons or
directions: A / B / X / Y / L / R / ZL / ZR / Up / Down / Left /
Right / L3 / R3.
To set one of the mappable buttons as an action button or
direction, follow these steps:
1. Press and hold the Program button for five seconds. The
second and third player indicator LEDs will flash.
2. Press either the M1 or M2 button.
a. If the M1 button is pressed, only the third player indicator
LED will continue to flash.
b. If the M2 button is pressed, only the second player
indicator LED will continue to flash.
3. Press your desired button or direction.
4. Press the Program button again to exit. The player indicator
LED will show the original player status.
To use the macro function, follow these steps:
1. Press and hold the Program button for five seconds. The
second and third player indicator LEDs will flash.
2. Press either the M1 or M2 buttons.
a. If the M1 button is pressed, only the third player indicator
LED will continue to flash.
b. If the M2 button is pressed, only the second player
indicator LED will continue to flash.
3. Press your desired pattern of buttons or directions. You can
choose a pattern of up to 32 function changes.
4.Press the Program button again to exit. The player indicator
LED will show the original player status.
4
To Next Page
