7. MAINTENANCE
Each time after end of work:
➢
Clean thoroughly the vise.
➢
Dismantle the
clamping inserts.
➢
Clean inserts, jaws and thrust plates.
➢
Cover the surfaces of inserts mating with the jaws with some grease.
➢
By means of mounting bolts set the correct position of inserts to obtain the
required value of L dimension (point 5.5).
➢
Preserve the vise with the anti-corrosive.
8. WORK SAFETY REGULATIONS
➢
Operator must read this instruction before attempting to operation.
➢
In case of abnormal work of spacer or damages, stop the work and inform
supervision staff.
➢
Qualified personnel must perform repairs and overhauls.
➢
Except mentioned above regulations observe your local safety rules.
9. FINAL REMARKS
➢
Following the instructions given in this manual provides long lasting and
trouble-free vice operation.
➢
Failing to do this will void any manufacturer warranties and liability.
Manufacturer reserves the right to make the construction changes without notice
General Terms and Conditions of a Guarantee and Complaint of the
“BISON” S.A. Company Ltd. Products – are given in the
www.store.bison-chuck.com
To Previous Page
Loading...