Bison BS7500 - Starting and Stopping the Engine; Engine Starting Procedure

MTBE (methyl tertiary butyl ether)
You MAY use gasoline containing up to 15% MTBE by Volume.
Before using an oxygenated fuel, try to confi 「 m the fuel's contents. Some states
(provinces in Canada) require this information lo he posted on the pump. If you notice
any undesirable operating symptoms, switch to a conventional unleaded gasoline. Fuel
system damage or performance problems resulting from the USE Of an oxygenated fuel
are not ours responsibility and are not covered under warranty.
| NOTlCE | °xygenatedfuelscandamage paintand plastic. Becareful notTo
spill fuel when filling your fuel tank. Damage caused by spilled
fuel is not covered under warranty.
6. STARTING/STOPPING THE ENGINE
Starting the engine
句 ． Make sure that AC circuit breaker IS IN THE OFF position.
The generator may be hard to start if a load is connected.
®· Turn the fuel valve to the- ON position
®· Turn the choke lever or to the CLOSE position, or pull the choke roc out to the
CLOSE position.
@. start the engine
With recoil starter:
Turn the engine switch to the ON position.
Pull the starter grip until compression is felt, then pull bri3kly.
| NOTlCE | l notallowthestartergriptosnap backagainsttheengine.
Return, fit gently to prevent damage to the or housing.
With electric starter (Optional kit)
Turn the engine switch to the START position and hold it there for 5 seconds or
until the engine starts.
15