Bison BS7500 - AC Operation Steps; DC Operation and Battery Charging

| NOTlCE | Substantial overloading will switch offthe circuit breaker.
Exceeding the time limit for maximum power operation or
slightly overloading the generator may not switch the- circuit breaker OFF. but
will shorten the service life of the generator.
Limit operation requiring maximum power to 30 minutes.
For continuous- operation, do not exceed the rated power
In either case. the total power requirements (VA) of all appliances connected must be
considered. Appliance and power tool manufacturers usually list rating information near
the model number or serial number.
4)
AC Operation
(
CD .
Start the engine
`\
@.
Switch the AC circuit breaker ON
@.
Plug in the appliance
Most motori?sd appliances require more than their rated wattage for startup.
Do not exceed the current limit specified for any one receptacle. if an overloaded
circuit causes the AC circuit breaker to switch OFF, reduce the electrical load on the
circuit, wait a few minutes and then reset the circuit breaker.
5) DC OPERATION
DC Terminals
The DC terminals may ONLY be used for charging 12 volt automotive type batteries.
The terminals are colored red to identify the pos 仆 ive (+) terminal and black to identify
the negative (-) terminal. the battery must be connected to -he-generator DC terminals
with the proper polarity (battery positive to generator red terminal and battery negative
id the generator black terminal) .
9