Bissell COMPACT - Empty the Collection Tank; Clean Up After Use

9
www.BISSELLdirect.co.uk
2a.
3.
2b.
Operatis
Empty the collection tank
1. With foot, push the red power pedal, to turn off
and unplug power cord from outlet.
2. Remove the collection tank from base of unit.
a. Release collection tank latches (on each
side) by pulling up from the bottom of latch
and then out.
b. Carefully remove tank by lifting up on the
tank handle.
3. Carry collection tank to a toilet or sink. To
empty, pour out contents using opening at back
of tank.
4. Rinse collection tank thoroughly and replace
on unit.
5. Refill solution tank and continue cleaning.
Clean up after use
1. Unplug the unit.
2. Remove and rinse collection tank thoroughly.
3. Remove tank vent & foam filter (located on
top of the collection tank) and rinse.
4. Clean nozzle window by lifting latch and
removing nozzle from machine. Rinse under
running water.
5. 40N7 and 40H5 series models, pop out
CrossAction brush by pushing the tabs away
from each other and pushing down. Once the
brush pops out, rinse and replace by snapping
the tabs back into place.
6. When finished replace nozzle and secure
with latch.
NOTE: For best results, it is recommended
that the nozzle is cleaned after each use.
7. Remove lint and hair from red gasket in
base of unit. (Do not remove gasket)
8. Replace the collection tank on the base of
the machine and secure with latches.
6. 7.
3. 4.
5.