Rev. 1.00
- 17 -
SLP-D22**
[Table 0] DIP Switch 0 (only for SLP-D220E and D223E)
Function Description
Off Disable Ethernet when Power Save Mode is enabled Ethernet operation
during power save mode
On Enable Ethernet when Power Save Mode is enabled
[Table 1] Dip Switch 1
No Functions Details
Off 5.0 ips
1-1 Speed Selection
On 6.0 ips
4 3 2 Density
Off Off Off 6
Off Off On 8
Off On Off 10
Off On On 12
On Off Off 14
On Off On 16
On On Off 18
1-2
1-3
1-4
Density Selection
On On On 20
Off Normal Mode
1-5
Exhibition
Selection
On Demo Mode
Off Label Paper
1-6 Media Selection
On Thermal Continuous Paper
1-7 No Use Default --- off
Off Back Feeding Enable
1-8 Back Feed Option
On Back Feeding Disable
[Table 2] Dip Switch 2
No Functions Details
2 1 Baud Rate
Off Off 9,600 bps
Off On 19,200 bps
On Off 57,600 bps
2-1
2-2
Baud Rate
Selection
On On 115,200 bps
Off Detect Gap
2-3 Media Detection
On
Detect Black Mark
- Dip S/W 1-6 OFF: Reverse Side Black Mark
2-4 No Use Default --- off
Off SLCS,EPL,ZPL
2-5 Emulation
On DPL
Off Receive Buffer Full
2-6 Busy Condition
On
*Offline
*Receive Buffer Full
Off Enable
2-7
Paper End Sensor
Status
On Disable
Off Disable
2-8
Long Label
Split Printing
On Enable
To Next Page
Loading...
