Rev. 1.00
- 27 -
SLP-D22**
7. Appendix
7-1 Specifications
Item Description
Printing Method Direct Thermal Printing
Dot Density
SLP-D220: 203 dpi (8 dot/mm)
SLP-D223: 300 dpi (11.8 dot/mm)
Printing Width Max 54 mm
Printer
Printing Speed
SLP-D220: 152 mm/sec (6ips)
SLP-D223: 100 mm/sec (4ips)
Width 15 ~ 60 mm
Roll Max 130mm
Paper
Core 12.5 ~ 38.1mm (0.5 ~ 1.5”)
Input Voltage AC 100~240V
Frequency 50/60 Hz
AC
Adapter
Output Voltage DC 24V
Temperature
0 ~ 45 (Operating)℃
-20 ~ 60 (Storage)℃ Usage
Conditions
Humidity
(except for paper)
10 ~ 80 % RH (Operating)
10 ~ 90 % RH (Storage)
※ Note
- Printing speed can vary depending on the data transmission speed and combination of
control commands.
- This equipment is indooruse and all the communication hiring are limited to inside of
the building.
- The switch is the disconnecting device. Turn off switch from any hazard.
To Next Page
Loading...
