BIXOLON SPP-R200III Bluetooth Connection Manual

Rev. 1.00
- 3 -
SPP-R200III
1. Manual Information
This Bluetooth Connection Manual provides information on the connection of Bluetooth-
enabled iOS devices with the printer (SPP-R200III).
We at BIXOLON maintain ongoing efforts to enhance and upgrade the functions and
quality of all our products. In following, product specifications and/or user manual content
may be changed without prior notice.
2. Precautions
2-1 To connect the printer with another device via Bluetooth, the devices must be within
10m of one another. The connection is broken if the distance between devices
exceeds 10m.
2-2 The maximum separating distance may be shortened if transmission obstacles, such
as cement walls, are present.
2-3 If a device (such as a microwave oven, wireless LAN, etc.) that uses the same frequen
cy is present, transmission may be interrupted. Separate the printer and Bluetooth-
enabled device from such interrupting devices by a distance of at least 5m.
3. iOS MFi mode change
You can switch over to MFi mode which allows you to have Bluetooth connection with iOS
devices. (Note: Make sure that MFi mode must be on.)
3-1 Set-up by printer button
- Turn on the printer power.
- Push the power button and feed button for 2 seconds while paper cover is opened.
- After beep sound, close the cover.
- Reboot the printer after checking below message.
iOS mode enable!!
Please Reboot Printer!!
- Repeat above procedure to make MFi mode disable.
3-2 iOS mode check
- Implement Self Test
- If firmware version is Vxx.xx STOBa, iOS mode will be disable.
- If firmware version is Vxx.xx STOBi, iOS mode will be enable.

BIXOLON SPP-R200III Specifications

General

Ethernet LAN	No
Bluetooth	Yes
Bluetooth version	3.0+HS
Serial ports quantity	1
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technology	Wired
Type	Mobile printer
Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Product color	Black
Flash memory	32 MB
RAM capacity	0.064 GB
Built-in barcodes	1D, 2D, AZTECCODE, CODABAR (NW-7), Code 39, Code 93, Code-128 Codabar Library, Data Matrix, EAN13, EAN8, GS1 DataBar, ITF, MaxiCode, Micro QR Code, PDF417, QR Code, UPC-A, UPC-E
Media thickness	0.07 ± 0.005 mm
Maximum roll diameter	40 mm
Maximum printing width	48 mm
International Protection (IP) code	IP43
Battery voltage	7.4 V
Battery recharge time	2.5 h
Storage temperature (T-T)	30 - 70 °C
Operating temperature (T-T)	-15 - 50 °C
Operating relative humidity (H-H)	10 - 80 %
Mobile operating systems supported	Android, iOS

Weight and Dimensions

Depth	43.6 mm
Width	79.5 mm
Height	126.7 mm
Weight	228 g