Bizerba P220901037 - 21 Processing; 21.1 Configuring Resolution for Label Printing; 21.2 Automatic PLU Change

Automatic machine parameters Instruction manual GLM-I
270 38.019.129.001 en
20
20.12.2 Setting polarity for container light barriers
Here you can set the polarities for the container light barriers of the package ejector and
the dividers:
– <Polarity cont.-LB EJ>
– <Polarity cont.-LB D1>
– <Polarity cont.-LB D2>
– <Polarity cont.-LB D3>
– <Polarity cont.-LB D4>
– <Polarity cont.-LB D5>
– <Polarity cont.-LB D6>
– <Polarity cont.-LB D7>
Mode level: 5
<Automat> / <Etc> / <Polarities> / <Etc> / <Contain.- light barr.>
Touch softkey of container light barrier to be set until required setting is displayed.
20.12.3 Setting polarity for other inputs and outputs
The polarities for the following inputs and outputs are set here:
–
<Error input>
– <Error output>
– <Signal pckg weighed>
– <Disable transp.>
– <Signal label ready>
– <Paper status>
– <Belt freeze>
– <External Pac- kage marking>
– <Infeed control>
– <Fault output 2>
– <InqZer. po. corr.>
– <Polarity Compressed air>
Mode level: 5
<Automat> / <Etc> / <Polarities>
Touch the softkey for input and output to be set until the requested setting is dis-
played.