Section 9
Maintenance
9.1 INTRODUCTION
9.2 PREVENTIVE MAINTENANCE
9.3 SERVICE INFORMATION
9.4 TEST EQUIPMENT REQUIREMENTS
9.1 INTRODUCTION
This chapter gives information about preventive maintenance and ser-
vice information of the unit.
9.2 PREVENTIVE MAINTENANCE
Please follow the following preventive steps to ensure the proper op-
eration of your instrument.
l Never place heavy objects on the instrument.
l Never place a hot soldering iron on or near the instrument.
l Never insert wires, pins or other metal object into ventilation fan.
l Never move or pull the instrument with power cord or output lead. Especially never
move instrument when power cord or output lead is connected.
l Do not obstruct the ventilation holes in the rear panel. As this will increase the
internal temperature.
l Do not operate the instrument with the cover removed unless you are a qualified
service technician.
l Clean and recalibrate the instrument on a regular basis to keep the instrument looking
nice and working well.
Remove any dirt, dust and grime whenever they become noticeable on the Outside
cover with a soft cloth moistened with a mild cleaning solution.
13
To Next Page
Loading...
Need help?
General
