6
CHARGING PROCEDURE
THE BATTERIES IN YOUR TOOL
ALL OF THE SAFETY INSTRUCTIONS.
NOTE:
by
BLACK+DECKER
2.
figure B.
The state of charger indicator (7) LEDs
(insert figure B
WARNING:
connected to the charger.
WARNING: Fire Hazard.
IMPORTANT CHARGING NOTES
was sent from the factory in an uncharged
2. DO NOT charge the batteries in an
and best performance can be obtained
if batteries are charged when air
BLACK+DECKER
service center.
NOT CONTINUE using product with its
STATE OF CHARGE INDICATOR
The battery is equipped with a state of
during use and during charging. It does not
Checking state of charge:
NOTE: Do not check state
reading. To receive an
Depress the trigger switch (1).
the percent of charge in the battery.
SAFETY WARNINGS AND
INSTRUCTIONS: DRILLING
WARNING: Tool may stall (if
overloaded or improperly used) causing
a twist. To reduce the risk of injury
always expect the stall.
ASSEMBLY AND ADJUSTMENT
INSERTING AND REMOVING BITS
figure D.
D
C
C1
B
To Next Page
Loading...
