7
NOTE:
WARNING:
position.
OPERATING INSTRUCTIONS
PIVOTING THE TOOL HEAD (FIGURES E, F)
pivot release button (3) shown
in figure E.
shown in figure F.
WARNING: Check to make sure tool
handle is locked after pressing pivot
release button and changing
screwdriver positions.
WARNING: To avoid being pinched at
the screwdriver at both ends and use your
thumb to depress the pivot release button
(3) when changing positions.
TRIGGER SWITCH & REVERSING BUTTON
trigger switch and depress the forward/
NOTE:
LED LIGHT
SCREW DRIVING
(button pushed to the right) for removing
fastener is at the desired depth.
NOTE:
DRILLING
GENERAL DRILLING TIPS
masonry.
instructed in the safety Instructions.
instructions.
instructed in the safety instructions.
out of it.
bit. Use enough pressure to keep the bit
STALLED TOOL OFF AND ON IN AN
WARNING: It is important to support
F
E
3
To Next Page
Loading...
