Black & Decker BDUR1 - Troubleshooting; Vacuum Not Powering On; Weak Suction Issues

20TROUBLESHOOTING
1. Unplugged at wall outlet.
2. Tripped circuit breaker/blown fuse at
household service panel.
1. Full or clogged dust bin.
2. Clogged airow passages.
3. Dirty lters.
4. Dust bin open.
5. Broken drive belt.
1. Plug in rmly, push ON/OFF button.
2. Reset circuit breaker or replace fuse.
1. Empty dust bin.
2. Clear airow passages.
3. Change/Clean lters.
4. Close hood until release button is latched.
5. Replace belt.
CAUSE
CAUSE
SOLUTION
SOLUTION
VACUUM DOES NOT POWER ON
WEAK SUCTION
Questions? Contact Customer Service
Phone: 855-454-8078
WARNING: Always turn o and unplug vacuum before performing
maintenance to the appliance. Failure to do so could result in electrical shock
or perosonal injury.
Review this table to find do-it-yourself solutions for minor performance
problems. Any other serivce needed should be performed by other qualified
service agent.