@
Accessories Include
1. Plastic panel - from 20" up to 46" ... 3 Pieces
2. Window panel adaptor .................. 2 piece
3. Screws ............................................ 4 pieces
4. Exhaust hose connector .................. 4 pieces
5. Exhaust hose .................................. 2 piece
6. Cover ........................................... 2 piece
@
.......ii,
®
1. Adjust the plastic panel to the width or height of your window and
tighten the 2 screws that are attached to the panel.
2. Push the round window panel adapter through the rear of the plastic
panel. Line up the holes and tighten the adapter with 4 screws that are
included in the kit (tighten screws from the front).
3. Install the window plastic panel into the window. If necessary, use duct
tape to better secure the panel.
4. Connect the exhaust hose to the unit by inserting the hose connector that
is attached to the hose into the exhaust.
5. Move the unit to the window, extend the hose and attach the other end
of the hose to the window. Align the tabs on the hose and window
panel adapters and fasten them together.
6. Plug the power cord into the wall outlet to prepare for operation.
B
® Hose Connector ® Exhaust Hose Q Hose Connector
4
To Next Page
Loading...
