1. Lid
2. Vortex showerhead
3. Brew basket (Part # CM1110-01)
4. Sneak-A-Cup™ auto pause feature
5. Carafe with lid (Part # CM1110-02)
6. Control panel
7. Water reservoir
8. Water level markings
9. Nonstick “keep hot” carafe plate
HOW TO USE
This product is for household use only.
GETTING STARTED
1. Remove all packing material, any stickers, and the plastic band around the power plug.
2. Go to www.prodprotect.com/blackanddecker to register your product.
3. Wash removable parts as instructed in CARE AND CLEANING.
4. Clean the inside of your coffeemaker by running two full brewing cycles with water only, no coffee.
Pour fresh, cold water into the water reservoir up to the 12-cup MAX mark, then place carafe onto the carafe plate.
Plug cord into standard electrical outlet.
Push the ON/OFF ( ) button to immediately brew water through the coffeemaker without adding coffee.
Once the cycle is finished, discard water.
Turn off appliance, unplug and allow to cool down for 15 minutes before repeating.
PROGRAMMING YOUR COFFEE MAKER
Setting the Digital Clock
To Next Page
Loading...
