EasyManuals Logo

Black & Decker GL7033 User Manual

Black & Decker GL7033
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
ENGLISH
(Original instructions)
Using an extension cable
Always use an approved extension cable suitable for the
power input of this appliance (see technical data). The
extension cable must be suitable for outdoor use and marked
accordingly. Up to 30 m of 1.5 mm2 HO5VV-F extension cable
can be used without loss of product performance. Before use,
inspect the extension cable for signs of damage, wear and
ageing. Replace the extension cable if damaged or defective.
When using a cable reel, always unwind the cable completely.
Additional safety instructions for grass trimmers
Warning! Cutting elements continue to rotate after the motor
is switched off.
u Be familiar with the controls and the proper use of the
appliance.
u Before use, check the power supply cord and extension
cord for signs of damage, ageing and wear. If a cord be-
comes damaged during use, disconnect the cord from the
mains supply immediately. DO NOT TOUCH THE CORD
BEFORE DISCONNECTING THE SUPPLY.
u Do not use the appliance if the cords are damaged or
worn.
u Wear stout shoes or boots to protect your feet.
u Wear long trousers to protect your legs.
u Before using the appliance, check that your cutting path is
free from sticks, stones, wire and any other obstacles.
u Only use the appliance in the upright position, with the
cutting line near the ground. Never switch the appliance
on in any other position.
u Move slowly when using the appliance. Be aware that
freshly cut grass is damp and slippery.
u Do not work on steep slopes. Work across the face of
slopes, not up and down.
u Never cross gravel paths or roads while the appliance is
running.
u Never touch the cutting line while the appliance is running.
u Do not put the appliance down until the cutting line has
come to a complete standstill.
u Use only the appropriate type of cutting line. Never use
metal cutting line or shing line.
u Be careful not to touch the line trimming blade.
u Take care to keep the mains cable away from the cutting
line. Always be aware of the position of the cable.
u Keep hands and feet away from the cutting line at all
times, especially when switching on the motor.
u Before using the appliance and after any impact, check for
signs of wear or damage and repair as necessary.
u Never operate the appliance with damaged guards or
without guards in place.
u Take care against injury from any device tted for trimming
the lament line length. After extending new cutter line
always return the machine to its normal operating position
before switching on.
u Always ensure that the ventilation slots are kept clear of
debris.
u Do not use the lawn trimmer (edge trimmer), if the cords
are damaged or worn.
u Keep extension cords away from cutting elements.
Labels on appliance
The following warning symbols are found on the appliance:
Read the manual prior to operation.
Wear safety glasses or goggles when operating
this appliance.
N
Wear suitable ear protectors when operating this
appliance.
E
Always remove the plug from the socket before
inspecting a damaged cable. Do not use your
strimmer if the cable is damaged.
K
Beware of ying objects. Keep bystanders away
from the cutting area.
R
Do not expose the appliance to rain or high
humidity.
Directive 2000/14/EC guaranteed sound power.
Electrical safety
#
This appliance is double insulated; therefore
no earth wire is required. Always check that the
power supply corresponds to the voltage on the
rating plate.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
u Electric safety can be further improved by using a high-
sensitivity 30 mA Residual Current Device (RCD).

Table of Contents

Other manuals for Black & Decker GL7033

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Black & Decker GL7033 and is the answer not in the manual?

Black & Decker GL7033 Specifications

General IconGeneral
Power sourceElectric AC
Line diameter2 mm
Product colorBlack, Red
Plant protectorYes
Rotational speed7000 RPM
Height adjustment100 mm
Line length supplied10 m
Cutting diameter (max)330 mm
Quantity per pack1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Weight3200 g

Related product manuals