MODEM 32144
74
4. General Operation and Special
Features
4.1 Quick Reset
For a reset of the modem, whereby
option settings are not changed but
the modem is cleared for a new
start and the ROM memory chip is
checked, select RESET from MAIN
MENU screen 3. The modem will
display the power-on screen for a
few seconds and then the EIA
status screen. This feature enables
you to reset the modem without
powering down the unit.
4.2 Storing Phone Numbers
4.2.1 U
SES
The front panel PHONE screen
allows you to store a single phone
number to be used later for—
• Autodialing from the front
panel or using the Hayes or
V.25 bis mode autodialer
• DTR dialing
• Leased-line or dial-line auto-
recovery.
This chapter describes the
following features and operational
modes (listed here in the order in
which they are presented):
• Quick reset
• Phone number storage
• Automatic fallback
• Dumb mode and Bell 208
operation
• V.13 operation
• DTR dialing
• Dial Line Auto-Recovery
• Leased Line Auto-Recovery
• Security operation
• Modem-controlled remote
control
• Diagnostic interface control
The status screens, which display
data concerning the operational
status of the modem, are discussed
in Section 7.6 . Instructions for
using the pushbutton controls and
LCD are included in Section 3.2.
To Next Page
Loading...
