9
1. 8 7 7. 87 7. 2 26 9 BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7.877.2 269
CHAPTER 2: INSTALLING THE SWITCH
2.4 CONNECTING THE AC POWER CORD
STEP 1: Connect the AC power cord to the AC power receptacle of switch.
STEP 2: Connect the other end of the AC power cord to the AC power outlet.
STEP 3: Check the SYS LED. If it is ON, the power connection is correct.
FIGURE 2-4. CONNECT THE AC POWER CORD
2.5 CONNECTING THE DC POWER CORD
STEP 1: Insert the negative/positive DC wires into the V-/V+ terminals, respectively.
STEP 2: To keep the DC wires from pulling loose, use a small flat-blade screwdriver to tighten the wire-clamp screws on the front
of the terminal block connector.
STEP 3: Insert the terminal block connector prongs into the terminal block receptor.
STEP 4: Check the SYS LED. If it is ON, the power connection is correct.
DC power input
FIGURE 2-5. CONNECT THE DC POWER CORD
To Next Page
Loading...
