CHAPTER 4: BASIC OPERATIONS
28
Figure 4-5. Devices Dialog Box
When the ServSelect III switch discovers a cascaded switch, you will notice the port
numbering change to accommodate each server under that switch. For example, if the
switch is connected to user port 6, the switch port would be listed as 06 and each server
under it would be numbered sequentially 06-01, 06-02 and so on.
To assign a device type:
1. In the Devices dialog box, select the desired port number.
2. Click Modify. The Device Modify dialog box displays.
Figure 4-6. Device Modify Dialog Box
3. Choose the number of ports supported by your cascaded switch and click OK.
4. Repeat steps 1 to 3 for each port requiring a device type to be assigned.
5. Click OK in the Devices dialog box to save settings.
NOTE:
Changes made in the Device Modify dialog box are not saved until you click OK
in the Devices
dialog box.
To Next Page
Loading...
