41
CHAPTER 5: Operation
Extender is locked, you will have to press [Enter] to clear those characters so
that they won’t invalidate the password when you proceed to type it in.
• Use {Hotkeys} + [Enter] to cause the Extender to go into configuration mode.
See Section 4.2.2.
Examples of how to enter these hotkey commands (assuming the hotkeys are
[Ctrl] and [Shift]):
• To blank the attached monitor’s video:
Press and hold [Ctrl] and [Shift], press and release [0] (zero), release [Ctrl]
and [Shift].
• To password-lock the receiver:
Press and hold [Ctrl] and [Shift], press and release [L], release [Ctrl] and
[Shift].
To Next Page
Loading...
Need help?
General