- Only use chargers supplied and approved by Black Hawk
Electric and never attempt to bypass or override the protection
circuits.
- Do not attempt to wash the skateboard with water or high-
pressure water washers.
- Avoid getting water near or into the charge port.
- Do not fit or install any voltage measuring devices to any
components.
- Always make sure that the charger port is dry before you connect
the charger cord.
- Do not submerge the battery, skateboard or charger into water. If
you suspect the batteries or skateboard have been submerged
or experienced water intrusion, do not attempt to remove the
batteries.
- Do not plug the charger into the board if the skateboard, battery,
motors or charger has been submerged or exposed to water
ingress.
- As will all rechargeable batteries, do not charge near flammable
material or liquids.
- If you use, charge or store the skateboard outside the limits
specified, you may void the warranty. You may also damage
your batteries and/or experience a reduced range and
inconsistent battery charging.
- Do not leave the skateboard charging or stored in any room,
dwelling, vehicle or confined space that is above 30° Celsius or
below 5° Celsius. Leaving your skateboard in a hot vehicle may
cause damage to the battery, motors, vehicle or surrounding
environment.
- Lithium Ion batteries are classed as, “Hazardous Materials.”
Transporting Lithium Ion batteries by air or other methods may
be prohibited by policies or law.
- Contact the designated company or agents transporting the
skateboard for their rules and regulations.
- Failure to follow these instructions could cause electric shock,
injury, burns or cause a fire.
To Next Page
Loading...