Truck Adjustments
Adjusting the turning ability of the skateboard is made simple with the
included multitool and the built in hex key. Whilst we recommend
leaving both front and rear trucks as is from new, higher speed riding
may require stiffer trucks to avoid becoming unbalanced at high speed.
To tighten your trucks, connect your multitool to the black nut of the
truck and tighten to the right in a clockwise direction. Only small
adjustments are needed. To loosen, reverse the above. Be sure never
to loosen the trucks too much as this is a serious safety risk.
Component Removal
Whilst removing any components without permission from Black Hawk
Electric may void your warranty, replacing a wheel/tire or removing a
truck is made simple with easy to access fixings just as the axles and
wheel mounts shown below.
To Next Page
Loading...