Black Nova ARIA - Thermostat Parameters; Thermostat Configuration Section; Thermostat Display Section

ARIA and ALBA KNX Keypad Panels - Operation and Maintenance Manual
Page 17/21
Thermostat Parameters
Thermostat parameters are visible once thermostat is enabled in general parameters
Configuration section
Parameter
Description
Operation mode
Selection for operation mode
In control unit mode control logic done by keypad
Default setpoint temperature (°C)
Default setpoint temperature when panel powered up
Maximum setpoint temperature (°C)
Maximum setpoint temperature can be set by keypad
Minimum setpoint temperature (°C)
Minimum setpoint temperature can be set by keypad
Correction value setpoint temperature
Increase or decrease setpoint value on the bus as correction value
Send setpoint temperature
Select the when setpoint going to be sent to bus
Setpoint step
Select setpoint step when setpoint increase or decrease command received
Fan speed 1 value (%)
Enter the % value for fan speed 1
Fan speed 2 value (%)
Enter the % value for fan speed 2
Fan speed 3 value (%)
Enter the % value for fan speed 3
Speed steps
Select the speed steps according to what thermostat unit support
Display section
Parameter
Description
Default Display Mode
Select display mode as Celsius or Fahrenheit when keypad powered up
Display brightness
Brightness level of display
Standby mode
Enables the standby mode: once passed the specified amount of time set at “Standby
Timeout” field the display brightness is set to “Standby mode brightness coefficient”
value.
Sleep mode
Enables the sleep mode: once passed the specified amount of time set at “Sleep
Timeout” field the display brightness is set to “Sleep mode brightness coefficient”
value.
Show real temperature
Enables the show real temperature mode: Once passed the specified amount of time
set at “Delay time to show real temperature” field the display shows real temperature
value.
Show real temperature in FCU OFF mode: Enables the show real temperature when
FCU is off.