Operation Instruction
Power on/off
● Press the power button until the device is on,the red indicated light will be on.
Working Mode
● Press mode button can set up: DIV、RX1、RX2、AV IN、HDMI IN model.
● Video TV system set-up(except HDMI mode): Press menu button to enter ‘function’,then
‘Video sys’ to choose PAL or NTSC.
● Under DIV、RX1、RX2 modes,you need press menu button first to enter RF to set up the frequency
band to make sure,the device Work with the transmitter in the same band.
Diversity Mode
● The due antenna diversity receiver is made up of ANT1、ANT2 and receiving circuit,according to
their RSSI output,the device can keep receive the strongest signal all the time. and maximize
image display stability.
● Antenna LED will show the current stronger one.
● < - > and < + > button controls the channel change.
● DIV AV OUT outputs diversity receiving signal for video recorder and external display purposes.
DIV AV OUT ONLY works under the diversity mode.
RX1 and RX2 Mode
● Under this mode, the channel of RX1 and RX2 can be set up separately; can set up the current
shown video signal of RX1 or RX2 by mode button.
● < - > button controls RX1 channel,< + > button controls RX2 channel.
● RX1 AV OUT and RX2 AV OUT output the corresponding channel of themselves,the device can
receiver the video signals from 2different transmitters at the same time.
If there is only one transmitter working, there is no different to use RX1 and RX2.
If there are two transmitters working,Please pay attention to adjust the bang and the
channel,let each other dose not affect the image effect.
AV IN Mode
● For inputting external video and audio signal.
● In AV IN mode, wireless receiving circuit automatically shut down to save battery life.
HDMI Mode
● HDMI can input HD video to show much clearer image,and automatically adapt to the resolution
(the maximum input 1920X1080/60Hz).
● In HDMI mode,wireless receiving circuit automatically shut down to save battery life.
Press the mode button in the HDMI mode, may slow response, this is a normal
phenomenon, because HDMI mode requires multiple attempts to connect with an external
device, after success connecting,the device can quickly display.
To Next Page
Loading...