! WARNING
NEVER APPLY COLD
WATER ACROSS THE
WHOLE SURFACE OF A
HOT GRIDDLE AT ONCE.
This may cause warping.
! CAUTION
DO NOT USE SOAP ON
THE GRIDDLE COOKING
SURFACE. This will destroy
the griddle’s seasoning.
STEP
To clean griddle aer
each use, cool griddle below 300° F.
Scrape food debris with spatula or
straight metal scraper.
CLEANING THE GRIDDLE COOKING SURFACE
STEP
Wipe down griddle
surface with paper towel.
STEP
Divide griddle surface
into approximately 6" sections
(width of scraper tool). Apply a
small amount of water onto rst
section with a bottle and then
scrape the water and debris toward
the grease trap. Move to the next 6"
section and repeat.
DO NOT USE MORE THAN TWO
TABLESPOONS OF WATER
AT A TIME.
1/4 cup of table salt may be used to
bu o stuck food residue.
STEP
Wipe again with a
paper towel and dry completely.
STEP
Apply thin coat of
cooking oil to maintain seasoning
and protect the griddle top.
NEED HELP?
Register your Blackstone product at
blackstoneproducts.com/register and
contact Blackstone Customer Service for
missing parts, assembly and operation
questions:
PHONE:
435-252-3030 ext 1
EMAIL:
support@blackstoneproducts.com
ONLINE:
blackstoneproducts.com/pages/support
STEP
Place the griddle top onto the griddle body by aligning the four
pins to the corresponding holes. Place the grease cup on the back of the
griddle body in the center of the unit.
STEP
Screw in the LP bottle
into the gas regulator, turning the
tank clockwise.
Make sure the front pins are fully
seated in the holes, then push the
griddle top and hood back to lock
the griddle in place.
STEP
Attach the handle and
grommets to the hood with two
(2) M6 bolts.
STEP
Insert the gas regulator
into the gas line of the griddle. Turn
the collar of the gas regulator clock-
wise to secure it into the line.
STEP
Proceed to the Griddle Seasoning Instructions section
of the Care & Maintenance chapter. Enjoy cooking outdoors on your
Blackstone 22” Griddle Cooking Station!
Model 1891 | Owner’s Manual | | Owner’s Manual | Model 1891
10 11
Assembly Guide Assembly Guide
To Next Page
Loading...
