ENGLISHENGLISH
| Owner’s Manual
blackstoneproducts.com/support
ENGLISH
❷
❶
❸
STEP
Ensure that the gas
regulator is angled towards the
rear of the appliance, and that the
LPG bottle is positioned below
the regulator.
! WARNING
Do not lean over the appli-
ance while lighting.
! WARNING
If ignition does NOT occur
in 5 seconds, turn burner
controls OFF, wait 5
minutes and repeat lighting
procedure.
If burner does not ignite with
open valve, gas will continue
to flow out of burner and
could accidentally/inad-
vertently ignite with risk of
injury.
IGNITION |
PIEZOELECTRIC
PROPANE BURNER OPERATION
For proper ignition and operation of the appliance follow the steps below.
STEP
❶
Push the control knob in to start
gas owing.
❷
Turn the control knob counter-
clockwise to activate the starter.
❸
Adjust the temperature to
desired level.
Ignition | Piezo-Electric
ENGLISH
3-7mm
TROUBLESHOOTING
Visit BLACKSTONEPRODUCTS.COM/SUPPORT for additional
troubleshooting.
Section 01
PIEZOELECTRIC IGNITION
SYMPTOMS
01. Burner will not ignite with piezo ignition system
If ignition does not occur in 5 seconds, turn the burner controls o, wait 5
minutes and repeat the lighting procedure.
If this does not work, to determine the cause, please try to ignite your appli-
ance with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your appliance with a match
POSSIBLE CAUSES SOLUTION
01. Ignitor wire misaligned. Ensure that the ignition needle is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
02. Damage to the ignition system. Contact customer service for replace-
ment parts.
If you CAN NOT ignite your appliance with a match
POSSIBLE CAUSES SOLUTION
03. Burner tubes are not
receiving propane.
Please reference the Gas Flow section of
the Troubleshooting Chapter.
Ensure that the ignition needle is
positioned 3-7mm away from the
burner tube, positioned above a
burner hole.
TroubleshootingModel 2015
15
To Next Page
Loading...
