ENGLISHENGLISH
| Owner’s Manual
blackstoneproducts.com/support
ASSEMBLY INSTRUCTIONS
Please read all instructions thoroughly before proceeding. Ensure
that all plastic packing material and any transit protection is removed
before assembling.
Find a large, clean area to assemble your unit. Please refer to the parts list and
assembly diagrams as necessary.
! WARNING
• Do not mix old and new
batteries.
• Do not mix alkaline, stan-
dard (carbon-zinc) or
rechargeable (ni-cad, ni-mh,
etc.) batteries.
! WARNING
• Do not mix old and new
batteries.
• Do not mix alkaline, stan-
dard (carbon-zinc) or
rechargeable (ni-cad, ni-mh,
etc.) batteries.
ENGLISH
! WARNING
The manufacturer has made
every effort to eliminate any
sharp edges. However, you
should handle all compo-
nents with care to avoid
accidental injury.
Some parts may contain
sharp edges, especially as
noted in these instructions.
Wear protective gloves if
necessary.
! WARNING
The manufacturer has made
every effort to eliminate any
sharp edges. However, you
should handle all compo-
nents with care to avoid
accidental injury.
Some parts may contain
sharp edges, especially as
noted in these instructions.
Wear protective gloves if
necessary.
! WARNING
This appliance will be hot
during and after use. While
cooking, place unit on
heat-resistant and flame-re-
sistant surfaces to avoid
damage and injury.
! WARNING
This appliance will be hot
during and after use. While
cooking, place unit on
heat-resistant and flame-re-
sistant surfaces to avoid
damage and injury.
! WARNING
The manufacturer has made
every effort to eliminate any
sharp edges. However, you
should handle all compo-
nents with care to avoid
accidental injury.
Some parts may contain
sharp edges, especially as
noted in these instructions.
Wear protective gloves if
necessary.
! CAUTION
Two people are recom-
mended for the assembly of
this product.
! CAUTION
Two people are recom-
mended for the assembly of
this product.
STEP
Remove the griddle body from the packaging and place it upside
down on a at, smooth surface. Pull the locking pin to unlock the legs.
STEP
Use twelve (12) M6x12 bolts to install the upper legs onto the
wheeled leg assembly.
Model 2015
05
Assembly Guide
To Next Page
Loading...
