Black Stone 2020 - Burner Assembly Cleaning for Troubleshooting; Customer Support Contact

BLACKSTONEPRODUCTS.COM/SUPPORT
ENGLISH
| OWNER’S MANUALTROUBLESHOOTING
STEP 06
Carefully replace
burners and reattach, with
attention to the location of the
ignition needle.
STEP 01
Ensure that the gas is turned OFF at control knobs and gas
supply. Remove the griddle top.
CLEANING THE BURNER ASSEMBLY
To reduce chance of “flash-back” the procedure below should be
followed at least once a month when spiders are most active or
when your appliance has not been used for a period of time.
STEP 02
Carefully detach and
remove the burner.
STEP 03
Clean the inside of
the burner:
a. Run a bottle brush (not a wire
brush) or a sti wire bent into
a small hook through each
burner tube several times.
b. Use compressed air to blow
through the burner tube and
out the burner ports (Wear eye
protection).
STEP 04
Brush entire
outer surface of burner to
remove grime.
STEP 05
Clean any blocked ports
with sti wire such as an open
paper clip.
VIDEO TUTORIAL
How to Clean Your Burner Tube
 youtube.com/watch?v=xKQTCrFCzf8

The gas rail fuel nozzle
must be reengaged within the
burner opening.
Fuel nozzle
Fuel nozzle
Burner opening
Burner opening
CUSTOMER SUPPORT
Visit us online at BlackstoneProducts.com/support
for assistance concerning appliance use, replacement parts, or
your warranty.
CUSTOMER SUPPORT HOURS:

Monday – Friday
7:00 am – 5:00 pm (Mountain Time)
MODEL: 
