ENGLISH
BLACKSTONEPRODUCTS.COM/SUPPORT
OWNER’S MANUAL | ASSEMBLY GUIDE MODEL:
STEP 33
Use four (4) [GG] expansion bolts to anchor each post
foot base {B}.
Slide the peg of one (1) foot cover {C} into the key hole of one (1) foot
cover {C} for each post.
OUTDOOR STRUCTURE ANCHORING GUIDE
⚠ WARNING
If your BLACKSTONE BAR & GRILL is not properly anchored,
damage could occur.
It is highly recommended for maximum safety that you mount
and secure to wood or concrete footers. This is far better and
safer than using ground stakes.
If digging for foundation, please double check for possibility of any
underground utilities such as gas, telephone, cable or sprinkler lines.
Refer to your local building and city codes, ordinances, neigh-
borhood covenants, or height restrictions regarding this type of
structure for guidance on acceptable installation requirements.
Consider consulting a licensed contractor for assistance in the
anchoring of this product.
WOOD
Anchors should be drilled into
joists or reinforced blocking (not
only deck boards).
CONCRETE
Use a 1/2" drill bit (not
included) to pre-drill holes for
concrete anchors.
STEP 34
Use four (4) [EE] bolts to attach one (1) electrical power
cover {R} to post 1 {A1}. (Note: M3 screwdriver is included)
Use four (4) [EE] bolts to attach one (1) electrical power cover {R} to
post 2 {A2}.
Stick the magnetic hooks [MM] to the cross beams. (5 per side is
recommended.)
[GG] × 28
R
R
[EE] × 8
[MM] × 15
To Next Page
Loading...