Black Stone 6038 - Ignition and Burner Operation

ENGLISH
BLACKSTONEPRODUCTS.COM/SUPPORT
OWNER’S MANUAL | USING YOUR BLACKSTONE
Turn gas ON at the LPG cylinder
by turning the OPD hand wheel
counterclockwise 1 to 3 turns.
2. BATTERY POWERED IGNITION

DO NOT lean over the appliance while lighting.
STEP 01
Insert one (1) AA
battery (not included) under the
ignitor button.
Screw the button into place over
the positive terminal.
STEP 02
❶ ❶
Turn the control knob to OFF.
STEP 03
❷❷
Push and hold the ignitor button.
❸❸
Push and turn the control knob counter-clockwise to HIGH.
(Release the ignitor button when the burner lights.)
❹❹
Adjust the temperature to desired level.
IGNITION INSTRUCTIONS
1. CHECK VALVES
STEP 01
Turn knob to OFF position.
STEP 02
Push in knob and release. Knob should spring back.
If knobs
If knobs
DO NOT
DO NOT
spring back, replace valve assembly before using appliance.
spring back, replace valve assembly before using appliance.
STEP 03
Rotate knob to LOW then turn back to OFF. Knob should
turn smoothly.

WARNING
If burner does not ignite with open LPG cylinder valve, gas
will continue to flow out of burner and could accidentally/
inadvertently ignite with risk of injury.
Ensure gas is o at the supply shut o valve before checking
appliance valves.
❷❷
❸❸
❶❶
❹❹
1 to 3 turns1 to 3 turns
STEP 02
❶
❶
Push the control knob in to
start gas flowing. (WHITE)
❷
❷
Turn the control knob
counter-clockwise to activate the
starter. (FLASHING BLUE)
❸
❸
Adjust the temperature to
desired level. (ORANGE)
STEP 01
Press the ON button.
(Optional: Turn the dimmer
until it clicks to turn o the
puddle lights.)
2. ELECTRIC IGNITION

DO NOT lean over the appliance while lighting.
Make sure the appliance is plugged in.
❷
❷
❶
❶
❸
❸
Note: If the magnet in the knob is disconnected, the indicator light
will be orange. If the knob arrow is facing UP, gas is not flowing.
HEALTHY BURNER FLAME
PATTERN
HEALTHY BURNER FLAME
PATTERN
BURNER FLAMES ARE YELLOW
OR IRREGULAR
BURNER FLAMES ARE YELLOW
OR IRREGULAR
3. CHECK BURNER FLAME
Always check burner flame before use.
STEP 01
Light burners and rotate knobs from HIGH to LOW.
STEP 02
Look below the cooking top to view burners. When knob is at
HIGH, flames should be larger than when knob is at LOW.
3. CHECK BURNER FLAME
Always check burner flame before use.
STEP 01
Light burner and rotate knob from LOW to HIGH.
STEP 02
Look below the turntable to view burner. When knob is at
HIGH, flames should be larger than when knob is at LOW.
❶
❶
Flickers of yellow color.
❷
❷
Dark blue color.
❸
❸
Vibrant blue.
❶ ❶
Flickers of yellow color.
❷ ❷
Dark blue color.
❸ ❸
Vibrant blue.
If there is a sudden drop or low
flame issue, please reference the
Troubleshooting chapter.
If there is a sudden drop or low
flame issue, please reference the
Troubleshooting chapter.
❶
❶
❷
❷
❸
❸
❶❶
❷❷
❸❸
MODEL: 
