ENGLISH
12
TROUBLESHOOTING GUIDE
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Unit will not start. Battery not charged.
Internal componets too hot.
Brushes worn out.
Check battery charging requirements.
Allow tool to cool down.
Have brushes replaced by an authorized BLACK+-
DECKER service center.
Battery will not charge. Tool not connected to the charger.
Charger not plugged in.
Surrounding air temperature too hot or too cold.
Connect tool to the charger.
Plug charger into a working outlet. Refer to
"Important charging notes" for more details.
Move charger and tool to a surrounding air
temperature of above 40 degrees F (4,5°C) or
below 105 degrees F (+40,5°C).
Unit shuts off abruptly. Battery has reached its maximum thermal limit.
Out of charge. (To maximize the life of the battery
it is designed to shut off abruptly when the
charge is depleted.)
Allow battery to cool down.
Place on charger and allow to charge.
SERVICE INFORMATION
BLACK+DECKER offers a full network of company-owned and authorized service locations. All BLACK+DECKER Service Centers
are staffed with trained personnel to provide customers with efficient and reliable power tool service. For more information
about our authorized service centers and if you need technical advice, repair, or genuine factory replacement parts, contact the
BLACK+DECKER location nearest you, or visit us at www.blackanddecker.com
To Next Page
Loading...
Need help?
General
