ENGLISH • 17
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Unit will not start Cord not plugged in. Plug tool into a working outlet
Circuit fuse is blown. Replace circuit fuse. (If the product
repeatedly causes the circuit fuse to
blow, discontinue use immediately and
have it serviced at a BlACK+DECKER
service center or authorized servicer.)
Circuit breaker is tripped Reset circuit breaker. (If the product
repeatedly causes the circuit breaker to
trip, discontinue use immediately and
have it serviced at a BlACK+DECKER
service center or authorized servicer.)
Cord or switch is damaged Have cord or switch replaced at
BlACK+DECKER Service Center or
Authorized Servicer.
Dust is not being collected Sandpaper holes do not align Use Mouse® sandpaper with the
appropriate hole configuration..
Dust canister is full. Separate dust canister and gently shake
or tap to empty.
To Next Page
Loading...
Need help?
General
