Black+Decker BEG010 - Tool Use, Maintenance, and Troubleshooting; Operation, Maintenance, and Troubleshooting

11
ENGLISH
(Original instructions)
u Apply minimum pressure to work surface, allowing tool to
operate at high speed. Cutting rate is greatest when the
tool operates at high speed.
u Once a cut is begun and a notch is established in the
workpiece, do not change the angle of the cut.
Changing the angle will cause the wheel to bend and may
cause wheel breakage.
u Remove the tool from work surface before turning tool off.
Allow the tool to stop rotating before setting it down.
Use
Warning! Let the tool work at its own pace. Do not overload.
u Carefully guide the cable in order to avoid accidentally
cutting it.
u Be prepared for a stream of sparks when the grinding or
cutting disc touches the workpiece.
u Always position the tool in such a way that the guard
provides optimum protection from the grinding or cutting
disc.
Switching on and off
u Toswitchthetoolon,presstheon/offswitch(1).
u Toswitchthetooloff,releasetheon/offswitch(1).
Warning! Do not switch the tool off while under load.
Hints for optimum use
u Firmly hold the tool with one hand around the
side handle
and the other hand around the main handle.
u When grinding, always maintain an angle of approx. 15°
between the disc and the workpiece surface.
Maintenance
YourBLACK+DECKERcorded/cordlessappliance/toolhas
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning!Beforeperforminganymaintenanceoncorded/
cordless power tools:
u Switchoffandunplugtheappliance/tool.
u Orswitchoffandremovethebatteryfromtheappliance/
 tooliftheappliance/toolhasaseparatebatterypack.
u Or run the battery down completely if it is integral and then
switch off.
u Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
u Regularlycleantheventilationslotsinyourappliance/tool/
charger using a soft brush or dry cloth.
u Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
u Regularly open the chuck and tap it to remove any dust
 fromtheinterior(whentted).
Mains plug replacement (U.K. & Ireland only)
Ifanewmainsplugneedstobetted:
u Safely dispose of the old plug.
u Connect the brown lead to the live terminal in the new
plug.
u Connect the blue lead to the neutral terminal.
Warning! No connection is to be made to the earth terminal.
Followthettinginstructionssuppliedwithgoodqualityplugs.
Recommended fuse: 13 A.
Troubleshooting
Problem Possible cause Possible solution
Unit will not
start.
Cord not plugged
in.
Cord or switch is
damaged.
Plug tool into a
working outlet.
Have cord or switch
replaced at a
BLACK+DECKER
service center or
authorizedservicer.)
Grinding and cutting accessory chart
Grinding Wheels
Type 27 guard Type 27 guard
Unthreadedbackingange
Type 27 hubbed wheel
Type 27 depressed center
wheel
Threaded clamp nut