7
ENGLISH
(Original instructions)
• It takes a few seconds for steam to enter the cleaning
pad. The steam mop will now glide easily over the
surface to be sanitized/cleaned.
• Push and pull the steam mop slowly across the surface
to thoroughly steam clean each section.
• When you have finished using the steam mop, return the
handle (9) to the upright position, making sure that it is
supported and turn it 'OFF'. Wait until the steam mop
cools down (approximately five minutes).
Caution! It is important to monitor the water level in the
water tank (4). To refill the water tank and continue to
sanitize/clean stand the mop upright making sure that the
handle is supported and turn the steam mop 'OFF'. Unplug
the unit from the electrical wall outlet, refill the water tank (4).
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
with the handle (9) supported in the upright position when
stationary and make sure the steam mop is turned off when
not in use.
Protecting the environment
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your BLACK+DECKER product
needs replacement, or if it is of no further use to you, do not
dispose of it with other household waste. Make this product
available for separate collection.
• BLACK+DECKER provides a facility for recycling
BLACK+DECKER products once they have reached the
end of their working life. This service is provided free of
charge. To take advantage of this service please return
your product to any authorised repair agent who will
collect them on our behalf.
• You can check the location of your nearest authorised
repair agent by contacting your local BLACK+DECKER
office at the address indicated in this manual.
Alternatively, a list of authorized BLACK+DECKER
repair agents and full details of our after-sales service
and contact are available on the Internet at:
www.2helpU.com.
Technical data
Troubleshooting
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
FSMH13E5-B5 FSMH13E10-B5
Voltage V
AC
220-240 220-240
Power W 1300 1300
Tank Capacity ml 380 380
Weight kg 1.8 1.8
Problem Step Possible solution
The steam mop is not 1. Check the unit is plugged
turning on in at the wall socket.
2. Check the unit is
switched on using the
ON/OFF switch (1)
3. Check the fuse in the
plug.
The steam mop is not 4. Check the water tank
producing steam (4) is full .
NOTE: When first filled
or after running dry it
can take up to 45
seconds for steam to be
produced.
5. Check the steam
generation button is in
the ON position (2).
Where can I get 6. Refer to the assembly
further information/ chapter of the manual
accessories for for correct fitting of parts
my steam mop and accessories.
To Next Page
Loading...
