5
(Original instructions)
Speed selector (g. E)
u For drilling in steel and for screwdriving appli-
cations, slide the speed selector (10) towards
the rear of the tool (1st gear).
u For drilling in materials other than steel, slide
the speed selector (10) towards the front of the
tool (2nd gear).
Hints for optimum use
Drilling
u Always apply a light pressure in a straight line
with the drill bit.
u Just before the drill tip breaks through the other
side of the workpiece, decrease pressure on
the tool.
u Use a block of wood to back up workpieces
that may splinter.
u Use spade bits when drilling large diameter
holes in wood.
u Use HSS drill bits when drilling in metal.
u Use masonry bits when drilling in soft masonry.
u Use a lubricant when drilling metals other than
cast iron and brass.
u Make an indentation using a centre punch at
the centre of the hole to be drilled in order to
improve accuracy.
Screwdriving
u Always use the correct type and size of screw-
driver bit.
u If screws are difcult to tighten, try applying a
small amount of washing liquid or soap as a
lubricant.
u Always hold the tool and screwdriver bit in a
straight line with the screw.
Accessories
The performance of your tool depends on the ac-
cessory used. BLACK+DECKER and Piranha ac-
cessories are engineered to high quality standards
and designed to enhance the performance of your
tool. By using these accessories you will get the
very best from your tool.
To Next Page
Loading...
Need help?
General
