CF 300 – Flight Manual sect. 4 – Normal Operating Procedures
BY BLACKSHAPE
n° BPU/FM003 Rev 3 dtd 03/06/2014 Page 40
(1) Canopy and opening handle CHECK
(2) Tank Cap CHECK closed
(3) Left Main Landing Gear:
(A)Main Leg Conditions
(B)Shocks Conditions
(C)Tire wear
(D)Tire Pressure
(4) Leading Edge and Wing Skin (LH):
(A) CHECK Integrity, cleaning and good conditions
(B) CHECK inspections doors
Check the static / PITOT for possible contamination or obstruction
(5) Left Wing Tip:
(A) CHECK Integrity and good conditions
(B) CHECK strobe and navigation lights
(6) Left Aileron:
(A) CHECK Integrity and good conditions
(B) CHECK control fittings attachment points, control and joints
(7) Left Flap and hinges:
(A) CHECK Integrity and good conditions
(B) CHECK plays and controls
(8) Left Side Fuselage Visual Inspection
(9) Fixed horizontal tail plane:
(A)CHECK the leading edge, verify its cleaning
(B)CHECK fin junction
(10) Elevator:
(A)CHECK Integrity and good conditions of elevators
(B)CHECK control fittings and attachment points
(C)CHECK movements
(D)CHECK trim
(11) Vertical Empennage and Rudder:
(A) CHECK Integrity and good conditions
(B) CHECK control fittings and attachment points
(C) CHECK movements (min plays)
(12) Right Side Fuselage Visual Inspection
To Next Page
Loading...