6、Binding equipment
Open "H Band" --> My--> My equipment --> Binding equipment --> turn on.
After unlocking this function, when the watch syncs the data to APP, APP shall save the
data locally (if the user logs in without using any account) or upload to cloud (in case the user
logs with certain account).
7、Low-power consumption mode
Open "H Band" --> My --> My equipment --> Low-power consumption mode --> turn
on
After unlocking this function, both the wrist rotating screen-on time and message
notification screen-on time will be shortened and the message notification vibration sense
shall be weakened.
8、Switches setting
Open "H Band" --> My --> My equipment --> On-off state setting.
Set the on-off state of wearing checking, heart rate monitoring and connection
reminding, etc.
Wearing checking: after unlocking this function, the watch shall, before heart rate
measurement, check whether the user is wearing the watch correctly. If it is, then the watch
will start heart rate measurement or the induction lamp shall flash for a while and then go out
automatically with the screen off and the watch in standby mode.
Heart rate monitoring: After unlocking this function, the watch shall perform
automatic monitoring at regular intervals (every 10 minutes) and record relevant data. In case
it is bound to a mobile phone, the data shall be uploaded to APP.
Connection reminding: after unlocking this function, when mobile phone disconnects
from the watch the watch shall display connection reminding page with vibration, screen off
3S later.
To Next Page
Loading...