BLADEZ BF-6732 HRP - User Manual

Questions and Answers

R
Raymond LarsonAug 11, 2025
What to do if my BLADEZ BF-6732 HRP display doesn’t light up?
- A
  astoneAug 11, 2025
  If the display of your BLADEZ Exercise Bike doesn't light up, first, ensure the unit is turned on using the on/off switch. Check that the unit is plugged into a dedicated 120V, 20Amp outlet to ensure sufficient power. Inspect the line cord for any damage and replace it if necessary. Finally, check the fuse on the MCB.
C
curtiscabreraAug 16, 2025
Why does my BLADEZ BF-6732 HRP show error E1?
- N
  nlittleAug 16, 2025
  Error E1 on your BLADEZ Exercise Bike indicates a problem with the speed sensor or motor. Here's what you should check: * Check the speed sensor connection. * Check the R-Deck oil, as the running deck may not be lubricated. * Check the sensor position, as the speed sensor might be misaligned. * Replace the S-Sensor if the speed sensor is faulty. * Check the display cable connection, as the display cable might be loose. * Replace the MCB if it's faulty (D2 LED on). * Check the D-Motor connection, as the drive motor might be disconnected. * Replace the D-Motor if the drive motor is faulty.
D
David HarrisAug 22, 2025
What to do if BLADEZ BF-6732 HRP Exercise Bike shows error E6?
- W
  William RuizAug 22, 2025
  If your BLADEZ Exercise Bike displays error E6, it indicates a problem with the elevation motor or safety key. You should check the safety key and switch. Also, check the elevation motor connection. If the elevation motor screw is binding, clean and lubricate it. Check the zero position of the elevation motor, as the elevation motor might be out of range. Consider replacing the elevation motor if the E-Motor Potentiometer is faulty.
R
Robert MyersAug 29, 2025
How to fix error E4 on BLADEZ BF-6732 HRP?
- J
  Jessica HigginsAug 29, 2025
  Error E4 on your BLADEZ Exercise Bike means the heart rate is not being detected. Ensure you are holding the heart rate grip properly. If that doesn't work, the heart rate receiver or control board in the display might be faulty and needs replacement.
M
mjohnsonSep 3, 2025
What causes error E7 on BLADEZ Exercise Bike?
- D
  Diana BraySep 3, 2025
  Error E7 on the BLADEZ Exercise Bike is caused by the elevation motor being out of range. The suggested solution is to replace the elevation motor.