TREADMILL OPERATIONS
3.
At this point, the TIME window flashes asking you to input time value. Press
to set the desired exercise time or press
directly to start the exercise without
entering parameters.
Range of Time ：20~99 min，default value 30min，step is 1
The chart below is about self manual heart rate measurement
Error Signal
E1：The treadmill Can’t read the speed feedback value.
E6： Incline motor can’t work within the ADC range.
E7： Incline is higher or lower(over range).
** If any error signal happens, please contact with the manufacturer.
Note
：Mode button also functions as a switch from English to Metric System. The operations are
Press ENTER key and hold it for more than 10 seconds under start/ready status after starting the
treadmill. At this time, the window will blink with a 0 (English) or 1 (metric)
Press ＋－ key to select. After selected, press ENTER key to confirm.
17
or
as followed:
Age 253035404550556065
Target heart Rate
10SecondCount 262625242322222120
Beats per Minute 156 156 150 144 138 132 132 126 120
To Next Page
Loading...
