Operation
CAUTION:
DO NOT ATTEMPT TO CHANGE ATTACHMENTS WHILE MIXER IS IN
OPERATION. ALWAYS SHUT OFF MIXER BEFORE PLACING HANDS OR
KITCHEN UTENSILS NEAR ATTACHMENT OR IN THE MIXING BOWL.
OPERATING BOWL LIFT
The bowl is raised to working position by means of a lever located
on the right-hand side of the mixer. Once raised, the bowl will be
automatically located in its proper operating position. The bowl lift
is pro-adjusted to stop at the proper working position before the
mixer is shipped from the factory.
ATTACHING BEATERS AND WHIPS
The beaters and whips used with your mixer have been
designed to make fastening of the attachments positive and
rapid.
To engage the attachment, line up the slots in the attachment
with the drive pin on the beater shaft. Raise the attachment
and twist to the right. When released, the attachment will
drop slightly into full locked position.
To remove the attachment, grasp near the top, raise slightly
while twisting to the left and slide downward.
12
2. Speed Change Lever
3. "ON-OFF" Power Switch
4. Bowl Lift Hand Lever
5. Nameplate & Serial No.
6. Bowl Support
7. Attachment Spindle
8. Beater Shaft
To Next Page
Loading...
Need help?
General
