To Next PageTo Next Page
Need help?Do you have a question about the Blakeslee B-20 and is the answer not in the manual?
Key principles for operating the mixer, including starting speed, bowl positioning, and clearance.
Discusses absorption rate, batch size reduction, and speed effects on mixer capacity.
Instructions for raising the mixer bowl to its proper operating position using the lever.
Procedure for engaging and disengaging beaters and whips onto the beater shaft.
Guidance on safely changing mixer speeds using the lever while the mixer is off.
Procedures for draining transmission oil and removing the cover and screen.
Steps to remove the shift lever, snap ring, and disconnect electrical wires.
Procedure to remove the transmission/motor assembly and separate the motor.
Instructions for replacing the auxiliary hub seals and O-rings within the transmission.
Steps to loosen the setscrew and pry the auxiliary hub assembly out of the transmission.
Instructions for removing the bevel pinion shaft, tapping out the seal, and replacing O-rings.
Procedure for removing the cover screws and washers from the transmission housing.
Method for separating the cover from the transmission housing using a mallet.
Identifies causes and actions for mixers not starting or changing speeds.
Diagnoses overheating, smoke, and attachments striking bowls.
Addresses bowl raising problems, skipping transmission, and one-speed operation.
Corrective procedures for transmission slippage, inactivity, and worm gear failures.
Solutions for beater shaft problems and motor running without transmission operation.
General