CLEANING
IMPORTANT:
Always disconnect the appliance from the gas
and electricity mains before carrying out any
cleaning operation.
2)
HOT
PLATE
Periodically wash the hot plate, the enamelled stell
pan support, the enamelled burner caps
"A,
''€3"
and
"C"
and the burner heads
T'
(see
fig.
6
and
7)
with lukewarm soapy water. Following this, all parts
should be thoroughly rinsed and dried. Never wash
them while they are still warm and never use
abrasive powders. Do not allow vinegar, coffee,
milk, salted water, lemon or tomato juice from
remaining in contact with the enamelled surfaces for
long periods of time.
I
,
FIGURE
1
WARNINGS:
Comply with the following instructions, before
remounting the parts:
-Check that burner head slots have not
become clogged by foreign bodies.
-
Check that enamelled burner cap =An, "Bn and
"C" (fig.
6
and
7)
have correctly positioned on
the burner head. It must be steady.
-
The exact position of the pan support is
established by the rounded corners, which
should
be
set towards the side edge of the hot
plate.
-
Do not force the taps
if
they are difficult open
or close. Contact the technical assistance
service for repairs.
-
Correctly preserve the plate after use by
treating
it
with special products, easily
available on the market. This will keep the
surface of the plate clean and bright. The
operation will also prevent the formation of
rust,
FIG.
6
FIG.
7
To Next Page
Loading...
