EasyManua.ls Logo

Blanco BFD8XP - Programming; Immediate Programme Start; Delayed Programme Start

Blanco BFD8XP
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
21
12/ CLEANING YOUR APPLIANCE
EN
Fig. 15
AA
Fig. 14
CC
AA
CC
BB
AA
BB
CC
BB
20
11/ PROGRAMMING
EN
Advice :
Consult the Programmes table on the preceding pages to determine the programme you
need for the type of items, the quantity and the amount of food residue.
• CLEANING THE WASTE FILTERS
The filtration system consists of several
elements:
--
The waste filter.
--
The large main filter.
--
The micro filter.
The filters are located in the centre of the tub
and must be washed regularly to obtain
ooppttii--
mmuumm wwaasshhiinngg rreessuullttss..
Actions :
Before removing the filters, remove any
waste on the large main filter with a
sponge so that the waste does not block the
sprinkler arms. Orient the
rroottoorr
as shown in
the drawing. (Fig. 14)
Loosen the waste filter a quarter of a turn
and then remove it
.
Remove the main filter
.
Remove the micro filter screen
.
Carefully clean filters
,
and
under running water. (Fig. 15)
Reinstallation:
Proceed in reverse order, inserting filters
and and then .
Important :
Remember to lock the waste filter in
place by pushing it in fully and turning it
a quarter turn.
AA
AABB
CC
CCBBAA
CC
BB
AA
BB
CC
BB
AA
Programme time
remaining
End of programme
45'
15'
End
9h
6h
3h
45°C
70°C 65°C 55°C 50°C
BLANCO
Fig. 02
CC
AA DDBB EE FF
Immediate programme start
Press “
OOnn
/Off” , to switch on your appliance
and select your programme by pressing one but-
ton or the other or the Automatic pro-
gramme by pressing the AUTO button.
— When a programme is selected, the associated
light illuminates.
Press “Start/C” , the “In progress” light
illuminates. Close the door and the programme
starts.
- 45’, 15’ and End indicate the remaining time of
the cycle
A short audible signal (beep) confirm the but-
ton’s selection, except for the “On/Off” button.
Delayed programme start
After selecting your programme, press the
“Delayed Start”
button once twice or three
times depending on whether you wish to delay the
programme start by 3, 6 or 9 hours; the appro-
priate light illuminates.
Confirm by pressing “Start/C”.
End of the programme
The light flashes 15 minutes before the end of the
programme and then lights permanents once the
programme has finished.
Cancelling a programme
Hold down the “Start/
CC
button for a few
seconds.
FF
EE
FF
AA

Related product manuals