Operatin
manual BDC-654
8/16
info@blastrac.eu
4. Before operation
Before using the machine it is essential to inspect the machine.
It is not permitted to use the machine if the machine safety is not according the
checkpoints below.
Checkpoints of electrical safety
Use only extension cables for extending the main cable that are sized and marked
in accordance with the overall power consumption of the machine.
Electrical cables must be rolled entirely off of the reels.
Any damage to electric cables is not permitted
Use an electrical power supply connection with earth connection.
The main switch of the machine should be put to ‘Off’ before connecting to the
power supply.
5. Operation
Starting / stopping the machine
• Connect the dust hose to the machine.
• Connect the dust collector to the power supply.
• Switch on the main switch.
• Switch on first the compressor motor.
• Secondly switch on the fan motor.
• Carry out this actions in opposite sequence to stop the machine.
Work with the machine
• Regular check the contents of the dust-bin.
• Regular open the drain valve (item 17 page 5) to remove water from the air tank.
• Regular open the drain valve (item 13 page 5) to remove the collected water of
the water separator.
Interrupting work
• When temporarily interrupting the work (1/2 hour – 1 hour), turn off the fan unit
only. Pulse cleaning of the filter system will continue and will increase the life-time
of the filter cartridges.
• During a longer stand still of the dust collector, first switch off the fan unit. Let the
pulse cleaning cycle run for +/- 5 minutes. Switch off the compressor unit and
Main-switch.
• Disconnect the power-supply cable.
• Prevent unauthorized persons from getting access to the dust collector or take
measurements to prevent unauthorized working with the equipment.
To Next Page
Loading...
