EBE 350 E Operating Instructions
General
Emergency shutdown switch
The emergency shutdown is a red mushroom-shaped press switch.
Pressing this switch immediately interrupts power supply to all machine
components. Releasing this switch makes the control lamp “Power”
light up
Push buttons ”Drive ON/OFF”
Pressing the push button "Drive ON" switches the drive control on. The
machine can now move forward and backward by using the drive wheel
joysticks. Pressing the push button "Control OFF" switches the drive
control off.
Push buttons ”Fan ON/OFF”
Before pressing this button make sure that the filter unit is switched on
and working. Pressing the push button "Fan ON" switches the machine
fan on. An airflow is generated from the blast head towards the filter
unit.. Pressing the push button "Fan OFF" switches the machine fan off.
Push buttons ”Main blast ON/OFF”
Before pressing this button make sure that the shot valve is closed.
Pressing the push button "Main blast ON" switches the blast wheel
motor on. Pressing the push button “Main blast OFF“ cuts of the
motor power supply immediately. Pay attention that the blast wheel
will continue rotating for some time after pressing the OFF button!
Drive wheel joysticks left/right
Operating these joysticks together makes the machine run forward ot
backward. Releasing one of the joysticks makes the machine turn to the
left or the right.
Drive speed control
Although this indication does not allow direct reading of the actual
speed, it shows comparing numbers allowing the operator to set the
appropriate speed.
7
To Next Page
Loading...