EBE 350 E Operating Instructions
Transport
4.3 Operation conditions
Check the surface to be treated for loose parts (stones, screws, etc.)
and fluids (water, oil, etc.). The surface must be swept and cleaned if
necessary. Make sure that the machine can travel over all inequalities
on the surface. Small inequalities like weld seams or floor joints are
no barriers for the machine.
4.4 Operation
The machine is operated in accordance with the instructions given in
Chapter 5 ”Initial operation“.
Whenever the machine is not used for blast cleaning, the abrasive
valve must always be closed!
Please note that the illustrations are simplified.
4.5 Unit specifications
The main dimensions and unit specifications of the machine when
assembled are shown in Chapter 1 "Technical data“.
3
To Next Page
Loading...