11
ACR 4231-034
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
Important information
Traffic safety
As the driver of a motor vehicle, it is your
responsibility to pay attention to the traffic
situation at all times. Never use your car radio
in a way that could distract you. Should the
traffic situation become particularly deman-
ding, we would advise you not to use the
radio. Please keep in mind that you travel a
distance of 14 m per second at a speed of
only 50 km/h. When adjusting the volume,
make sure that you are still able to hear
sounds coming from outside of the vehicle,
so that you are always able to react to war-
ning signals.
QuickOut
This car radio is optionally available with or
without the QuickOut device.
Using the QuickOut handle you can easily
pull your radio out of the installation compart-
ment to take it along. The preset stations
remain stored for a longer time.
To take out the radio.
• press knob (a), take the handle (b) and
pull the unit out.
To listen to the radio or cassette again,
• insert the set into the compartment until
it stops and move the handle back to
the front panel.
Installation / Hook-up
If you would like to install your new car radio
yourself or add other audio components to
the existing ones, then please read the enclo-
sed instructions on installation and hook-up
carefully.
Do not ground the loudspeaker outputs!
Use only Blaupunkt-certified accessories and
spare parts.
Radio operation
Select the frequency range
You can choose between the frequency ran-
ges:
FM 87.5 – 108 MHz,
AM 531 – 1602 kHz and
LW 153 – 279 kHz.
• Switch on the desired frequency range
by pressing either the button FM•T or
M•L.
Switching between AM and LW:
• Press M•L.
Station search
m should not be lit up in the display. If it is,
switch it off by pressing lo • m
•
press right or left.
The car radio will automatically tune
into the next station.
If you hold the button pressed, the search
function will forward quickly.
Manual station search
m (manual) must be lit up in the display. If it
is not, switch it on by pressing lo • m.
•
press right or left quickly.
The frequency will move up or down in
short intervals.