Blaupunkt ALICANTE CD30 - Switching On;Off; Volume Adjustment; Setting the Power-On Volume

2727
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Volume adjustment
The system volume can be adjusted in
steps from 0 (off) to 66 (maximum).
➮ To increase the system volume,
turn the volume control 3 to the
right.
➮ To decrease the system volume,
turn the volume control 3 to the
left.
Setting the power-on volume
You can set the unit’s default power-on
volume.
➮ Pressing the MENU < button.
➮ Press the : button.
“ON VOLUME” appears in the display.
➮ Set the power-on volume using the
and buttons :.
To assist you in setting the power-on
volume, the volume will change in re-
sponse to the changes you make.
If you set the power-on volume to 0:
every time you turn the unit on, the
power-on volume will be the same as
the volume level that was set before the
unit was last switched off.
Risk of serious injury.
If the power-on volume is set to maxi-
mum, the volume level can be very
high when the unit is switched on.
If the volume was set to maximum
before the unit was switched off and
the power-on volume is set to 0, the
volume level can be very high when
the unit is switched on again.
This can cause hearing damage.
Switching on/off
There are various ways of switching the
unit on/off.
● Switching on/off using the vehicle
ignition.
If the unit is correctly connected to the
vehicle’s ignition, it will switch on/off si-
multaneously with the ignition.
You can also switch the unit on even if
the ignition is off.
➮ To do so, press button 4 until the
unit turns on.
Note:
To protect the vehicle battery, the unit
will switch off automatically after one
hour.
● Switching on/off using the remov-
able control panel.
➮ Remove the control panel.
The unit switches off.
➮ Attach the control panel again.
The unit switches on. The settings (ra-
dio, CD or CD changer) that were set
before the unit was switched off will be
reactivated.
● Switching on/off using button 4.
➮ To switch the unit on, press button
4.
➮ To switch the unit off, press button
4 for longer than two seconds.
VOLUME ADJUSTMENTSWITCHING ON/OFF