10
BASIC OPERATION (CONT.)
Setting the Alarm
The alarm settings must be performed while in STANDBY mode.
1. Press and hold the AL1(5) or AL2(6) button (00:00) will be flashing and be
shown on the display.
2. When ‘00:00’ is flashing, set the alarm time by repeatedly pressing HOUR(2) and
MIN(1), press AL1(5) or AL2(6) button to store the alarm time. And ‘Buzz’ or ‘FM’
will flash to stable.
3. Press HOUR(2) and MIN(1) button repeatedly to select the type of alarm (the buzz or
FM radio station), the source indicator will appear on the display.
4. Press AL1(5) or AL2(6) button again to confirm the alarm settings.
5. Press AL1(5) or AL2(6) button repeatedly to activate or deactivate the alarm timer
• If the alarm timer is activated, ‘BUZZ’ or ‘FM’ icon is displayed.
• If the alarm timer is deactivated, the alarm icon disappears.
6. To stop the ringing alarm, press the corresponding AL1(5)/AL2(6) button
or POWER/SOURCE (7) button. The repeats itself in subsequent days.
7. To cancel the alarm, press AL1(5) or AL2(6) button twice briefly, the alarm indicator
will disappears.
NOTE: When using the device, you can press and hold the AL1(5) or AL2(6) button to see
what time the alarm was set. Then the alarm time will briefly appear on the display. The alarm
volume is not adjustable, but it will go up gradually to gently wake you up.
To Next Page
Loading...
