12
RADIO OPERATION
LISTEN TO FM RADIO
1. Ensure the mains power is connected and powered ON.
2. Fully extend the antenna wire which is located at the rear of the apparatus.
3. Press the SOURCE (7) button repeatedly to switch to FM tuner mode.
4. Press the TUNING-(2) or TUNING+(1) button to tune into the desired
station manually.
5. press and hold the TUNING-(2) or TUNING+(1) button for two seconds tunes to
a station with strong reception automatically.
Store FM Radio Stations Automatically
1. In FM tuner mode, press and hold SCAN(4) for two seconds.
2. All available FM radio stations are stored automatically.
3. The first stored radio station broadcasts.
Store FM Radio Stations Manually
You can store up to 20 FM radio stations.
1. Tune to an FM radio station.
2. Press and hold PRESET(3) button for two seconds. The preset number begins
to blink.
3. Press TUNING-(2) or TUNING+(1) to select a number.
4. Press PRESET(3) again to confirm.
5. Repeat steps 1 to 4 to store other stations
NOTE: To remove a pre-stored station, store another station in its place.
Select a Preset Radio Station
In tuner mode, press PRESET(3) repeatedly to select a preset station.
To Next Page
Loading...
